Never perform electrical inspections to the airbags, such as measuring resistance.ĭo not position yourself in front of the airbag during removal, inspection, or replacement. 6: Do Not Store Airbag Near High Heat Source Store the removed airbag on a secure, flat surface away from any high heat source 5: Keeping Airbag Away From Oil, Grease, Detergent Or Water To prevent damage to the airbag, keep it away from any oil, grease, detergent, or water. 4: Storing Removed Airbag With Pad Surface Up Store the removed airbag with the pad surface up. Once an airbag has been deployed, itįor temporary storage of an airbag during service, observe the following precautions. For example, if itĭoes not rotate smoothly, replace the cable reel.ĭo not disassemble an airbag. If the cable reel shows any signs of damage, replace it with a new one. Other steering-related adjustment or installation INSTALLATION ), whenever the following is performed. Remote steering wheel controls, and the horn inoperative. Misalignment of the cable reel could cause an open in the wiring, making the SRS system, Power sliding door control unit (see RESETTING THE POWER SLIDING DOORĬONTROL UNIT ), and reset the power tailgate control unit (see RESETTING THEīefore returning the vehicle to the customer, enter the radio code, the navigation code, thenĮnter the radio station and XM channel presets set the clock. After reconnecting the battery, reset the Get the customer's anti-theft codes and write down the radio station and XM channel presetsīefore disconnecting the battery negative cable. The original radio and navigation system have a coded theft protection circuit.A tester with a higher output could cause accidental deployment and possible injury.ĭo not put objects on the front passenger's airbag. Its output is 10 mA (0.01 A) or less when switched to the lowest value in the ohmmeter If it is not a Honda multimeter, make sure Use only a digital multimeter to check the system. ![]() ![]() Of being dropped or improperly handled, such as dents, cracks or deformation.īefore removing any of the SRS parts (including the disconnection of the connectors), Use only new parts when making SRS repairs.Ĭarefully inspect any SRS part before you install it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |